Oops! I broke the 3D printer! And you know what? It’s OK.
Bits of a 3D printer, post hacksaw
One night on The 2nd Floor of the Chattanooga Public Library I attempted to make 3 Stretchlet bracelets on our 3D printer at one time. We’re taking our 3D printer to the local children’s museum later this month and wanted to built up our arsenal of 3D printed giveaways. My idea was to attempt to speed up that process and boy oh boy did it not work.
I came back to see the mess you see below. Something went wrong and our whole extruder was covered in plastic. I attempted to chip bits of the plastic but I had no luck. I called on James and Geoff from The 4th Floor to assess the damage. They took our 3D printer away, let us borrow one of theirs (thank you oh so much), and came back down 15 minutes later with the diagnosis: the electronics were a-ok, but they had to cut out some bits with a hacksaw. They contacted MakerBot support and the final verdict was in…
Thanks for contacting MakerBot Support! The part that are you are inquiring about can definately be purchased by contacting MakerBot Support at 347.334.6800 Option 2, MOnday through Friday 9am-6pm (EST).
The name of the part is called Extruder Carriage and the cost of the part is $12.
Phew. The 3D printer will be good to go in a week or so, and the damage wasn’t too bad. What did I learn besides the obvious “don’t make too many stretchlet bracelets at one time”? Well, it helped me see that even if I make a mistake with this 3D printer thing that it’s all going to be ok. It’s just a machine that can be fixed. It’s not the end of the world.
Now I have this awesome pile of plastic and bits of a 3D printer lying around that everyone on the 2nd Floor can show to tweens and teens and say “see, we messed up and that’s OK because we learned something.”
